expoweb/others/ubss/811427.htm

212 lines
11 KiB
HTML

<!DOCTYPE html PUBLIC "-//W3C//DTD HTML 4.0//EN">
<html lang=en>
<head>
<title>
81.1427: UBSS Intro to Austrian Karst
</title>
</head>
<body>
<font size=-1>Proceedings of the University of Bristol Spela&aelig;ological Society, 1981, <b>16</b>(1) pp5-10</font>
<h2>An Introduction to Austrian Karst</h2>
<h4>by S.R.Perry</h4>
<h3>Abstract</h3>
<p><font size=-1>The plateaux of the Northern Limestone Alps underwent uplift
between Miocene and Pliocene times due to pressure from the Central Alps. The
run-off from the Central Alps took a linear northerly direction to the
Northern Foreshore. Subsequent dissection separated the plateaux physically
and local radial drainage patterns developed. The surface features of the
plateaux are dependant on glaciation, solution and weathering. The plateaux
show good conditions for cave formation. This has occurred in two major
phases, late Tertiary northerly phreatic tunnels and post glacial radial
vadose development.</font>
<h3>Introduction</h3>
<p>This paper gives an introduction to the karst of Austria, as reviewed by
Bauer and Z&ouml;tl. (1972). It provides a background to the interest the
University of Bristol Spelaeological Society is now showing in the Loser
plateau area of the Totes Gebirge.
<p>Karstifiable rock makes up about one sixth of Austria. Four fifths of the
karst area lies in an east-west band of limestone, the Northern Limestone
Alps, which lies to the north of the Central Alps. The hardrock Central Alps
are separated from the Limestone Alps by the longitudinal rivers: the Inn,
the Salzach and the Enns. The Northern Limestone Alps include the High Alps
(summits greater than 2000m) and to their north the pre-Alps (summits less
than 1500m) (Fig. 1)
<p><img alt="Fig. 1 - 15k gif" width=780 height=450 src="81f1.png">
<p>The dominant rocks of the High Alps are the Triassic Limestones
Wettersteinkalk and Dachsteinkalk. Both are fine-grained, light coloured,
bedded strata up to 1500m thick. The pre-Alps contain many less permeable
rocks including dolomites and shales. They have suffered greater surface
erosion and show rounded hill forms, corroded flat in the Tertiary period
(Tertiary denudational plains). The classic features of the High Alps are
impressive steep sided, interdigitating plateaux and the corresponding
narrow valleys.
<h3>The Development of the Limestone Alps</h3>
<p>The Triassic limestones were subjected to tectonic pressure from the
Central Alps and suffered extensive nappe-type folding in the early Tertiary,
with overthrusts reaching up to fifty kilometres in a northerly direction.
The nappes were corroded by the run-off from the Central Alps and widespread
denudational plains were formed. During early Miocene these plains were
covered by a several hundred metre thick hardrock gravel blanket
(Augensteine) washed from the Central Alps. The Augensteine can still be
found, especially in the east of the range and where they have been deposited
within caves and fissures by water action (Fig. 2).
<p><img alt="Fig. 2 - 17k gif" width=720 height=450 src="81f2.png">
<p>During early Miocene, only a few hills would have shown above the
Augensteine, but with the uplift of the Alps from then to Pliocene times the
gravel cover was eroded away and widely extending plateaux were exposed. The
plateaux survive as the High Alps, where they are of extensive limestone
sequences (Wettersteinkalk and Dachsteinkalk) with low dip. These factors
have reduced surface erosion by the development of extensive subterranean
drainages. Such areas are termed 'Raxlandshaft' (Raxlandscape).
<p>The Raxlandshaft was dissected by younger tectonic block movements to form
the interdigitating plateaux. The subsequent down-cutting of valleys
interrupted the previous generally northwards drainage from the Central Alps,
which had formed the Tertiary denudational plains and the extensive
horizontal phreatic cave systems of Austria, The Limestone Alps were isolated
physically from the Central Alps by the Inn, the Salzach and the Enns, which
diverted the run-off from the Central Alps to the Danube. This valley
formation reached its present extent (and formed a hydrological barrier) by
the beginning of the Quaternary period. Subsequent drainage was local to each
plateau, with a radial distribution rather than a dominantly northern
direction. The final major event was the Quaternary glaciation.
<p>The limestone plateaux are most prominent in the isolated massifs of the
Steinernes Meer, Tennengebirge, Dachstein, Totes Gebirge and east as far as
the Vienna Basin. To the west a mountain chain form, the Northern Tyrolean
Alps, formed of steeply dipping Wettersteinkalk and of less spelaeological
interest, is continuous with the high alpine dolomite ranges.
<h3>Surface Features of the Plateaux</h3>
<p>Large karst features such as dolines predate Quaternary glaciation. The
glaciers themselves enlarged surface rifts to gouge out straight narrow
ravines several metres deep and up to one hundred metres or more long. These
'Gassenlandschaft' are characteristic of the glaciated plateau and indicate
the network of main faults and joints. Step-like scarps separated by flat
beddings, 'Plattenlandschaft', are found in areas of distinctly bedded
low-dip limestone, again due to glacial scouring. As the glaciers receded
(the Dachstein still has a glacier which was once 400m thick) the released
water aided the formation of numerous surface-open shafts, usually blocked
with surface moraine or glacial scree.
<p>Since the glaciation, small features, 'lapies', have developed: fine
sharply fluted 'Trittkarren' formed above the tree line (about 1600m) and
rounded bollard-like 'Rinnenkarren' up to one metre deep formed below the
tree line, under soil cover. There is a band of overlap due to the timber
line having fallen three to four hundred metres since the thermal maximum. On
the bare plateau, where hte temperature is low (increasing the carbon dioxide
solubility) and precipitation is high, post-glacial erosion is estimated at
15-20cm of limestone. Lower down the vegetation reduces the available water
(transpiration) but the acid soil increases the corrosive power of the
slightly warmer water. Trittkarren are centimetres deep, Rinnekarren up to
one metre deep. Above about 2200m, frost weathering is sufficient to prevent
lapies formation.
<h3>Hydrology</h3>
<p>The development of an underground drainage system depends on the amount
and structure of the bedrock, the surface morphology, the amount and quality
of the water having access to the surface, the position of the base level of
drainage (potential energy gradient) and the time available.
<p>The tendency to cave formation rather than surface run-off is greatest if
the surface is nearly horizontal. High precipitation and carbon dioxide
content help. Surface features, such as lapies and Gassenlandschaft, direct
water to the bedrock and subterranean drainage will then take advantage of
and enlarge the internal weaknesses, with flow directed by the local base
level. All the necessary factors, including depth of limestone are found
<i>par excellence</i> in the high plateaux around the Dachstein, though
changes in the parameters since Tertiary times have dictated several phases
of cave development.
<p>A limestone mass can be divided according to the drainage conditions in
various regions. Highest is a zone of vadose development, where passages are
essentially air-filled and gravity drives flow and passage formation
vertically down planes of weakness, usually joints and faults. At some depth
a level of permanent flooding is reached, where flow is dictated by
hydrostatic pressure and may travel in many directions to reach base level.
This phreatic zone is limited by the extent of the karstifiable rock. The
upper portions of this karst water body will experience the most rapid motion
and turnover, and will be the zone of greatest passage formation. This region
overlaps with the vadose region in a zone where water level and flow type
varies closely with the precipitation. A 9.7 km tunnel through the Schneealp
has allowed direct observation of these zones in a Wettersteinkalk plateau to
the east of the range.
<h3>The Caves</h3>
<p>The earliest phase of development is evidenced by Liassic deposits within
the Tertiary limestone. These pockets are not relevant to the present caves,
which divide into phreatic tunnels and precipitous vadose systems. The
phreatic tunnels run in a northerly direction, formed by late Tertiary
run-off from the Central Alps, before the latter were separated by their
longitudinal valley systems. This drainage ran through the Limestone Alps to
the base level of the northern foreshore and was associated with the
drainage which formed the denudational plains. At this time, several large
'poljes' are thought to have sat perhaps 1000m above the presnt plateau.
<p>The phreatic tunnels of the major known caves lie between 1300 and 1800m
above sea level. The systems often have several stories denoting successive
uplifting of the Alps during their formation, the phreatic tunnels being
formed in the upper, rapidly moving layer of the karst water body. The
Dachstein Mammut Cave is a classic example with 16.5 km of passage lying at
altitudes between 1250 and 1500m. The Eisriesenwelt Cave of the Tennegebirge
has 42km of passage between 1600 and 1800m.
<p>Late vertical developments, either connected with the horizontal passages,
as in the 432m shaft of the Geldloch, or in separate shaft caves, such as
the Gruberhornh&ouml;hle (854m total depth), were formed in the isolated
vadose zones of the Quaternary plateaux. Much of the water supply was
glacial and post-glacial meltwater (ie. local) and radial drainage patterns
were formed with overlapping water systems running centrifugally within the
plateau. Vertical connections in the Dachstein Mammut Cave betray their
links with the glacier bed above by the moraine deposited at their junctions
with the phreatic tunnels.
<p>Spore tests reflect both types of cave form. Radial patterns were found
for drainage from the centre of the Totes Gebirge. In contrast, drainage from
the southern edge of the Totes Gebirge (Tauplitz fault zone) passed 30km
north through the entire massif.
<h4>Reference</h4>
<p>Bauer, F and Z&ouml;tl, J, 1972<br>
In <i>Karst. Important Karst Regions of the Northern Hemisphere</i>,
Ed. Herak, M. and Stringfield, V.T.
<h4>Additional Reading</h4>
<p>Jennings, J.N., 1971<br>
<i>Karst.</i> M.I.T.Press
<hr>
<!-- LINKS -->
<img alt="&gt;" src="../../../icons/lists/0.png">
<a href="811309.htm">A Description of Some Caves</a>
in the Totes Gebirge (same UBSS Proc.)<br>
<img alt="&gt;" src="../../../icons/lists/0.png">
<a href="../../areas.htm">1623 Area overview</a><br>
<img alt="&gt;" src="../../../icons/lists/0.png">
Back to <a href="../../index.htm">Expedition Intro page</a><br>
<img alt="&gt;" src="../../../icons/lists/0.png">
<a href="../../../index.htm">Back to CUCC Home page</a><br>
<img alt="&gt;" src="../../../icons/lists/0.png">
<a href="../index.htm">Other groups</a> who have worked in the area
</body>
</html>